Post-vacation Assembly

Assembly

I'm back from my vacation and have spent a little time tonight working on the wall. I've finished attaching the velcro to the acrylic/contact paper and have basically finished the routing/securing of the cabling in the backside of the wall. I have yet to mount a few of the switches (microcontroller power switch, fan power switch), and I've got to glue some felt on a few places on the pegboard (for protection of the boards), as well as gluing the A/C power receptacle.

After all of that is done, all I need to do for this module's assembly is attach some blocks on the inside to allow me to secure the pegboard, as well as provide mounting brackets for hanging it. I will probably put 4 pieces on the top (all near the very top of the wall) and 2 pieces in the bottom. There really isn't a whole lot of room in the bottom, and I will have to rearrange some of the wiring as it is to make room.
Hopefully, it won't be too much of an issue. I was only planning on using Liquid Nailz to attach it, and that should definitely hold it well enough.


'Til next time...